Build process for my Wi Fi Sniper Rifle as inspired by Darren Kitchen over at hak5.org.

Materials

• ALFA USB WiFi AWUS036H
• 16dBi Yagi Antenna
• Table Top Tripod
• Zip Ties
• 2 Washers (I grabbed spare rack mount washers)
• Riflescope (to be added later, snapped the pot metal when attempting to mount)

• Phillips Screwdriver
• Pliers
• Scissors, knife, side cutters to cut zip ties
• Drill (preferably drill press)
• Drill bit and 1/4" - 20 tap 
• Smaller drill bit
• Ruler
• Sharpie and/or Punch

1. Find a nice mounting point about 1/3 up from the mounting bracket, in between two rivets and mark the center
2. Drill and tap that hole for the Tripod mount
3. Measure and drill the proper sized hole for your tripod alignment post
   >
4. Remove the mounting bracket from the 16dBI Yagi antenna and put it on the side with the rivets
5. Tie the AWUS036H to the mounting bracket using the zip ties, and trim as necessary
   
6. Coil the antennae wire nicely and use the cable ties that shipping with it to maintain the loop.  Connect to the AWUS036H.
7. Using the washers as a separator, mount the antennae to the tripod.
8. Mount the Riflescope TBD
9. Connect to your computer and enjoy